Sponsored links

For Sale NICE! Aeromotive #11104 Eliminator fuel pump (Black)

Aeromotive #11104 Eliminator pump, the newer "Black" version that outflows the previous "Red" version by ~30%, owned by me for the last (ugh, just realized) 5yrs. I've used it to empty a customer fuel tank for a sender swap, almost comical how FAST it did it (at only 12.4V). I bought it with only a...

Vendor or advertising

Hello. I have a product that I would like to promote on Corral. How do I become a vendor or advertise properly? Can I just put up the ad? Thanks

For Sale 1987 Thunderbird Turbo Coupe

For Sale: 1987 Thunderbird Turbo Coupe 5 Speed Manual Transmission 142087 Miles This car is in good condition runs and drives great. Comes with many extra parts -Extra Rear end with 3:73 gears

Hydroboost Conversion on Fox

Been scouring the net for a few hours reading up on swaps, just a couple questions. The 96-04 hydroboost setups are pretty much the same? No major differences in the boosing units through the years, or is there a particular year I should focus on getting? Seems they all have a straight...

Clean 1995 GT coupe

1995 GT 109,000 5 speed It has fresh 3 stage paint no cheap stuff 1500 in materials. I have gone completely through the motor all new gaskets. The heads have been replaced by brand new heads along with a B cam, 1.6 RR true roller timing chain. Trans completely gone through I replaced 2nd gear...

For Sale 2017 FORD F450 XLT

Nice 2017 Ford F450 XLT (wallworktrucks.com/buy-new-2017-ford-f450-xlt-north-dakota_vid_48346.html) Location: FARGO, ND Vin: 1FT8W4DT6HEB58631 Stock Number: H8870S Year: 2017 Engine: 6.7 DIESEL

For Sale Vortech 8 rib crank

Vortech 8 rib 6.87" for a 302. $140 shipped Pm or text 630-746-5153

WTB WTB: Bell Housing, 2 piece block shim plate, and clutch fork

WTB: Bell Housing, 2 piece block shim plate, and clutch fork for a T5 in a Fox body mustang. I also need a new throw out bearing and pilot bearing if someone has those items to bundle in.

fox style blower setup on a 94/95

I know some of the ysi blower guys go with a foxbody (pulley spacing,etc) drivers side mount on sn95's,and it appears to fit nicely and I know this topic has been asked about before,but is there anyone on here that has done it,on a typical passenger side vortech/Paxton setup? run a foxbody...

For Sale 87-93 Foxbody Vortech V-2 S

Hello, I have a Vortech V-2 S Foxbody supercharger kit for sale. It comes with everything needed to install and more. List of items included: Vortech V-2 S Crank pulley Stock headunit pulley as well as smaller, higher boost pulley

For Sale fab 9 rear end with AXLES AND CONTROL ARMS

54" fAB 9 REAR END WITH BIG FORD ENDS. Mittler brothers housing. Stock suspension mounts. Also included chromemoly control arms with big aurora rod bearings. Also comes with moser axles, star flange and gun drilled with 5/8 studs. 1700.00

WOT hesitation /bog

Just so you know what I'm dealing with: Edelbrock Performer heads, Comp 266HR cam, Edelbrock Performer RPM intake, Edelbrock 70mm TB, 80mm PMAS slot MAF calibrated for 30lb injectors, red top FRPP 30lb injectors, 2.5" exhaust, AOD. All of this is controlled by a stock, unturned A9P. The Thermactor...

94 Cobra Swap Opinions

Hello Corral, I am new to the forums and am looking for opinions on motor swaps into my 94 Cobra. The current motor in the car is a bolt on 302 with about 250,000 miles on it and is beginning to show its age and am looking for more from the car. My goals for this build are as follows: 400-500...

For Sale Qa1 K member and control arms 96-04

For sale qa1 k member and control arms 96-04 300.00

New personal best vid whoring.....

Daily commuter still getting down, even up here in Salt Lake City Utah's 4,400ft elevation.... Last event of the year last October 14th. Personal best last year was 12.18@113.33 1st pass https://www.youtube.com/watch?v=S6pzYZoyNK8&index=10&list=PLq_5ull3kUe-_O0h8EcFgdRZ1voUwtrvx 2nd Pass...